MIMAKI JV3-160S Guide d'installation télécharger pdf (Page 118)

– 5.28 –

5-3-14. MEDIA COMP2

[Function]

Corrects the amount of media feed at the time of plotting.

The correcting values are stored under the system parameters No. 20.

• Do not change this value in the field.

• Make this adjustment only if a problem occurs when the media is normally set and

the following pattern is plotted using a combination of MIMAKI-brand Grossy White

PET(SPC-0111) and MIMAKI-brand colorant ink.

Reason : This adjustment changes the reference value for media correction. With

this change, the four types of [SET UP - MEDIA COMP.] for the user are all changed

and therefore the user needs re-adjustment.

The image shown at left is an

image when the circled section

above is observed with a scope.

Make adjustment so that

the 2-pass dots are shot

between 1-pass dots.

Good sample Bad sample

- adjustment + adjustment

* Since only the feed direction (X direction) is adjusted, the hatched dot pattern may not

result.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 169 170

Pas de commentaire

MIMAKI JV3-160S Guide d'installation Page 118