MIMAKI JV5-130S Spécifications télécharger pdf (Page 77)

3-7

Setting the media on the printer

This printer can be used with roll media and cut sheet media. Use the media recommended by MIMAKI.

(Refer to ?Sizes of media that can be used (p.1-16)? )

 If a transparent media is set, the message [ERROR 50 MEDIA DETECT] is dis-

played and the media may not be detected.

 If the media is exposed to direct sunshine, the media width may not be

detected correctly.

 Do not use printed media; otherwise, ink can adhere to pinch rollers and thus

media may be stained or may not be detected.

 Significantly or internally curled media must be straightened so that it will be

fed properly without floating above the platen.

 Media may form an irregular surface because of the heat from the post-heater if

it is left set on the printer for a significant period of time. If printing is started on

the irregular surface of the media, the heads may rub on the media. Therefore,

if an irregular surface is found on the media, feed the media with the [] key

and set a new origin to avoid printing on the irregular surface.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 291 292

Pas de commentaire

MIMAKI JV5-130S Spécifications Page 77