MIMAKI JV5-130S Spécifications télécharger pdf (Page 85)

3-15

Setting the media on the printer

When the media thickness cannot be detected

There may be a case where the media thickness cannot be detected properly depending on the media.

In such a case, the media thickness must be input manually.

STEPS:

1 An error is displayed, and the carriage returns to the station.

2 Input a value of the media thickness using the [] or [] key and press the [ENTER]

key.

Initial value: 0.1 mm; Input range: 0.1 mm to 1.0 mm

3 Press the [] key twice to select ROLL. (Press the [] key twice to select LEAF.)

The carriage moves and detects the media width.

Thickness detection is also performed here if the [END] key is pressed at step 2 above.

When [ThicknessDETECT] of [MACHINE SET] function has been set to

MANUAL

The detected thickness of the media is always input manually.

Even if the same media is used, when the thickness is different, it is convenient to set to MANUAL.

STEPS:

1 Select [Roll]

2 Input a value of the media thickness using the [] or [] key and press the [ENTER]

key.

Initial value: 0.1 mm; Input range: 0.1 mm to 1.0 mm

3 The carriage moves and detects the media width.

∗∗∗∗∗ ERROR 50 ∗∗∗∗∗

THICKNESS DETECT

The thickness of the

media is inputted.

(range : 0.1 - 1.0 mm)

thickness = 0.1 mm

MEDIA SELECT

ROLL < > LEAF

The thickness of the

media is inputted.

(range : 0.1 - 1.0 mm)

thickness = 0.1 mm

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 291 292

Pas de commentaire

MIMAKI JV5-130S Spécifications Page 85