MIMAKI JV3-130SPII Spécifications télécharger pdf (Page 102)

- 5.12 -

When media thickness is changed [PRINT ADJUST]

When the media thickness, head height, ink type is changed, the dot position is subtly

different. This function corrects the dot positions to ensure that the accurate plotting result

is obtained.

The dot positions are corrected by comparing the ink dropping positions on each of the

seven test patterns between the two plotting directions.

• When in use of the roll media, the back side of roll media will loosen after

executing print adjust, for the media returns to the plot original point.

STEPS:

1. Select the [PRINT ADJUST].

page 5.2.

2. Press the [ENTER] key.

3. Press the [ENTER] key.

Plotting of the test patterns for the correction of dot position

starts. There are seven types of test patterns that are plotted.

4. Press the JOG keys [ ] and [ ] to correct the

dot position of pattern 1.

The seven test patterns that are output are sequentially

named [PATTERN 1] to [PATTERN 7].

Select the correct dot positions on [PATTERN 1] using the

JOG keys [ ] and [ ].

Select the dot positions that make a straight line on the test

pattern in the two plotting directions.

• If the pattern correction value for straight lines is

not within -40 through +40, adjust the head height

and then correct it again with [PRINTADJUST].

MAINTENANCE

PRINTadjust < ent >

MAINTENANCE

PRINT START : ent

MAINTENANCE

PATTERN 1 = 0. 0

Out put direction

Select the dot positions 4.0 that

make a straight line on the test

pattern in two plotting direction.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 141 142

Pas de commentaire

MIMAKI JV3-130SPII Spécifications Page 102