MIMAKI JV5-320S Spécifications télécharger pdf (Page 84)

3 Printing

3-12

[2] Set a media to the feeding side (Back of the printer)

Set a heavy-duty roll media to the heavy-duty feeding device on the back.

STEPS:

1 At the back of the printer, open the right and left covers of heavy-duty feeding device,

and take out the roll shaft to set media.

2 Remove heavy-duty roll holders on both sides of the shaft.

1.Loosen screws (1 each on the right and left) with supplied ratchet handle.

2.Remove the holders.

 Since roll media is heavy, set it by more than 2 people. Take care not to drop it

on the foot, and not to hurt your waist.

 Handle clamp levers carefully.

Do not push the lever up when tension-bar is lifted. Be sure to fix the tension-

bar with the lock and push up / down the lever.

 When carrying the roll shaft, be sure to grip handles on the both ends. Gripping

other parts, your hand may get stuck in the printer.

Be careful not to hurt your waist.

 To prevent dust, set paper core or media to the roll shaft on the table or sheet.

Dust on the paper core or the media may cause defective print.

Handle

Cover

Ratchet handle

Roll holder

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 297 298

Pas de commentaire

MIMAKI JV5-320S Spécifications Page 84