3-3
Setting the media on the printer
Setting the media on the printer
This printer can be used with roll media and cut sheet media. Use the media recommended by MIMAKI.
(Refer to ?Sizes of media that can be used (P.1-2)? )
Leaf media cannot be used with this machine.
In the cases below, be sure to fix tension-bars on both sides of the printer.
If you leave the tension-bars unfixed, the bars supported by media may fall down.
Please be careful.
When lifting up the clamp lever
When cutting media with tools you have (cutter, scissors, etc.)
If a transparent media is set, the message [ERROR 50 MEDIA DETECT] is displayed and
the media may not be detected.
If the media is exposed to direct sunshine, the media width may not be detected cor-
rectly.
Do not use printed media; otherwise, ink can adhere to pinch rollers and thus media
may be stained or may not be detected.
Significantly or internally curled media must be straightened so that it will be fed prop-
erly without floating above the platen.
When setting media, make the center of the roll media match the center of the main
body.
This printer can print on the media setting on the right side, however, some types of
media tend to cause skew (media is fed on a skew) or sticking on the platen. By setting
media in the center, the printer stably feeds the media.
The following media cannot be used:
• Meandering media on both edges
• Media whose thickness is not even
• Media whose edge is folded or whose state changed noticeably
Commentaires sur ces manuels