3 Printing
3-22
Use method of rear surface dryness fan
When drawing on the fabric media, ink broke through to the rear side of the media may impact on the drawing
surface after take-up because ink does not get dry. In this case, use the rear surface dryness fan to dehydrate
ink on the rear surface.
STEPS:
1 Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2 Select [SET UP] using the [FUNCTION] key and press the [ENTER] key.
Select type 1 to 4 and press the [ENTER] key.
3 Select [DRYNESS FAN] by pressing the [] key and press the [ENTER] key.
4 Press the [ENTER] key to proceed to the lower hierarchy and with the [][] keys,
set the strength of the dryness fan.
After setting the strength of the dryness fan, register it with the [ENTER] key.
5 Press the [END] key several times to return to LOCAL mode.
If you use the rear surface dryness fan, the media may be lifted.
You can avoid the media from being lifted by using the heavy media feeding/take-up
machine, or adjusting the strength of the fan.
L. ∗ > [JV5-01]
width : ∗∗∗∗ mm
SET UP
SELECT : TYPE1
FUNCTION
SET UP <ENT>
[1]
DRYNESS FAN <ent>
[1]
MEDIA FEED <ent>
9
times
Setting value :
OFF, WEAK,
Little WEAK,
STANDARD, STRONG
[1]DRYNESS FAN
SET UP : STANDARD
Commentaires sur ces manuels