MIMAKI JV5-160S Spécifications télécharger pdf (Page 100)

CHAPTER 3 Print Output Setting the reference value for dot misalignment correction

3-28

5 Press the [] or [] key to correct the dot position of pattern 1.

Select the correct dot position on [PATTERN 1] using the JOG key [] or [].

Select the dot position where the dots of outward trip and those of homeward trip form a straight line on the test

pattern.

6 Press the [ENTER] key.

7 Subsequently repeat Steps 5 and 6 seven times to make PG DROP ADJUSTMENT on

Pattern 2 to Pattern 8.

Select the correct dot position on each of the patterns.

Enter the adjusted values on Patterns 1 to 8 and then terminate PG DROP ADJUSTMENT.

8 Press the [END] key several times.

The printer returns to LOCAL mode.

 Dots may be slightly out of alignment even after [PG DROP ADJUST.] is made.

In such a case, perform [DROP.POScorrect] of [MAINTENANCE].

The procedure for [DROP.POScorrect] is the same as that for [PG DROP

ADJUST.], but the test patterns to be used are [Pattern 1] to [Pattern 4].

(See 3-36)

Input COMP value.

-40.0 - +40.0

PG DROP ADJUST.

PATTERN1 = 0.0

Input range:

Patterns 1 to 8

-40.0 to 40.0

Output direction

The dots at the fourth position counted

from the zero position in the positive

direction form a straight line.

In this case, the adjusted value is 4.0.

Input COMP value.

-40.0 - +40.0

PG DROP ADJUST.

PATTERN2 = 0.0

Input range:

Patterns 1 to 8

-40.0 to 40.0

PRE PRT AFT

35°C 40°C 50°C

L. ∗ > [JV5-01]

width : ∗∗∗∗ mm

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 261 262

Pas de commentaire

MIMAKI JV5-160S Spécifications Page 100