MIMAKI JV5-160S Spécifications télécharger pdf (Page 220)

CHAPTER 6 Operation for Functions Applied settings of functions

6-30

Detailed settings of heaters

Make settings of the pre-heater, print-heater and after-heater built in the platen.

The temperatures of heaters can be adjusted even during printing so that optimum temperatures can be

obtained.

However, it takes a heater a few minutes to more than ten minutes to reach the set temperature depending

on the ambient temperature.

The temperature settings made here will be kept until the power is turned off or they are changed under any

of the following conditions:

 Types are changed in FUNCTION mode.

 Heater temperatures are changed in FUNCTION mode.

 The heater temperatures are set on the computer.

Setting value of temperature

Rough guide for temperature setting

*1 Adjust each heater temperature to a value best suited to the media conditions.

 Use this printer at 20-35° to ensure reliable printing. The heater temperatures

may not rise to the set values depending on the ambient temperature.

 The heater temperatures can be controlled on your application software if it

has a function to do so.

For setting on the application software, refer to the instruction manual for your

application software.

° C OFF, 20~60 (70) ° C (In steps of 1 ° C)

° F

OFF, 68~140 (158) ° F (In steps of ° F)

* There may be some values that cannot be set in steps of 1 ° F.

Heater ES3 ink (media) HS ink

PVC Tarpaulin FF All types of media

Pre-heater 40 40 40 40

Print-heater 40 40 40 40

After-heater 50 50 50 50

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 261 262

Pas de commentaire

MIMAKI JV5-160S Spécifications Page 220